Friday, November 09, 2012

Remember the Status Bar and Think Edges

Two little practical tips or reminders for Friday morning.

Tip One - Revit doesn't see things until you place your cursor near the edge of an element. There are some exceptions but for most elements you've got to move the cursor near an edge. Not sure if Revit sees it? Is it highlighted? No, then Revit doesn't see it. No point clicking to select something if Revit doesn't acknowledge it. The highlighting is visual confirmation that Revit thinks "this" is what you want to select.

If it isn't the correct one, remember the TAB key cycles through alternate elements that Revit could see in the same spot. I imagine sonar radiating from the tip of the cursor. If an element is close enough to bounce a signal back to the cursor you can "sink the battleship". No "Disco Tabbing", that happens when you hold the tab key down instead of just pressing once or twice as needed. I say disco because elements flash at you when you hold the button down. Thanks to Cyril Verley for that, I heard it from him first.

Okay that was three tips already; Edges, Highlighting and the TAB key.

Tip Two - When you are busy remembering edges don't forget to remember the Status Bar. It tells you what Revit sees or wants from you. When you place your cursor near an element you get the highlighting, you should see a tool tip AND the Status Bar offers you some info too. It's like a read-only command line, sssh.

1 comment:

Unknown said...

Disco tabbing is a good one. I'll have to use that because I see it far too often. Short or long, your tips are almost always appreciated. Great work.