Tuesday, December 06, 2011

Tab Key and Selection

Read a post by Luke at What Revit Wants regarding a tip he heard in Chad Smith's AU Virtual session, 45 Autodesk Revit Tips in 45 Minutes. It reminded me that I created a video of it to demonstrate it a couple years ago. Here's what I wrote back in October 2009 regarding this tip.

This is subtle feature of using the TAB key that many users are not aware of. First of all, it is easier to see than to describe so you might as well watch the VIDEO.

Two items:
  • Select Entire Chain of Walls or Lines
  • Select Partial Chain of Walls or Lines
First item - Hover cursor over a wall or line > Press TAB key once (Walls or lines highlight) > Left Click to select.

Second item - Select a wall or line > Hover cursor over a different wall or line somewhere along the path > Press TAB once (Walls or lines highlight) > Left Click to select. The subtle difference is that which direction the selected chain travels depends on which end of the element you hover your cursor over. Watch and then try it!

NO DISCO tabbing, as my friend Cyril says. Just press the TAB key once. You get the disco tabbing when you press and hold the TAB key down. We call it Disco because the highlighted lines will flash at you.

Last comment, make sure you hover and then hold your mouse steady. If you move the mouse away after highlighting the chain the TAB feature fails. You have to make sure everything is highlighted still before using the Left mouse button to select them. It is a process unlike any other software you are familiar with most likely. Practice a couple times if you aren't already very comfortable with it.

Here's the video...


2 comments:

Unknown said...

Is there anything about Revit that you haven't posted before Steve! :-) You are a legend mate.

Steve said...

yep, in my own mind! :)